FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

All FAQs (1904 total: showing 161-180)

Why did Campbell Scientific start using molecular sieve? Does it have the same effect as the previously used chemicals?
Can molecular sieve be used in the future to replace bottles for gas analyzers sold before July 2017?
If a CS110 electric field sensor is installed in complex terrain, such as on a ridgeline in alpine territory, what is the effective range (spatial range) of the instrument, and how might it differ from a flatland site?
Does the CR1000X have a Thermistor() instruction similar to the CR6?
In the event that the CR1000X becomes damaged and needs a new wiring panel, what should be done?
How does the power usage of the CR1000X compare to the power usage of the CR1000 or CR6?
Can a program written for a CR1000 be used on a CR1000X?
Can a CS320 be calibrated to a smaller range to measure only PAR (photosynthetically active radiation)?
How can the CS320 be mounted if the 18356 leveling base is not used?
Is it possible to read the output from a CS320 in a 4 to 20 mA form?
On routine site visits, how can the calibration of the CS320 be checked?
How often does the CS320 need to be recalibrated?
What is the difference between a thermopile pyranometer and a silicon photocell pyranometer?
How can an end user simulate a lightning strike to an SG000 or CS110?
If a CH150 or PS150 is hooked up to both solar and ac power supplies, which power supply does the device use?
Which software updates are free?
Is the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH well suited for all environments?
In terms of a network link interface, what is "bridge mode"?
For the CPEC200, is the heater on the vortex intake controlled the same way as it was prior to the addition of the vortex intake?
Has the vortex intake changed the way the pump for the CPEC200 works?

Previous Next