FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

All FAQs (1904 total: showing 1781-1800)

What is the optimum calibration frequency for a WindSonic?
Is it possible for a WindSonic to operate in extreme conditions like snow, glacial temperatures, and freezing rain?
Where is the interface cable for the WindSonic?
Can vertical wind speed be measured by rotating the WindSonic 90 degrees?
Can the WindSonic produce an output of 4 Hz or higher frequency?
The WindSonic has the average 1 Hz output of 40 Hz block measurements. What does the 40 Hz block measurement mean?
Is it possible to connect a sonic anemometer and an electronic compass to a smart datalogger to give wind speed and direction on a non-fixed platform?
If data is downloaded to a PC, the resultant “CR1000_Table1.dat” file is, for example, 150 kB in size. Is 150 kB necessarily its size on the CR1000? Is there any type of data compression being used?
Can the CR1000 or CR3000 communicate over TCP/IP?
Can the CR1000 measure 4 to 20 mA signals?
What would it take to make the CR1000 wireless?
Is a separate extension cable for a 05106-L available? The current cable is approximately 13 ft long, and it would be helpful to extend the cable another 20 ft.
What is the power consumption (mA) of the 05103-L, 05103-45-L, 05305-L, and 05106-L anemometers?
What is the procedure for orienting a WindSonic-L to the cardinal directions, so that the wind direction readings are correct?
What is the voltage output range for the 21X?
If the 21X was turned off before the data was downloaded using PC208W, what can be done?
Do the 21X dataloggers have a built-in security code that might be activated under certain conditions when upgrading the program?
Can the CR5000 store data with a rate of 1000 Hz?
What happens to a 21X program when the batteries fail?
Is the 03101-L capable of delivering a 0 to 5 Vdc square wave output for the wind speed?

Previous Next